The vise is made of die-cast zinc and has three machined sides. The grooved base fits perfectly the adjustable fence of of the Drill Press.
The jaws are 2" (50 mm) wide and 25/64" (10 mm) high and provide horizontal and vertical V-slots for holding round work pieces.
The maximum clamping width is 1 11/32" (34 mm).
Very compact design. Noryl casing (heat resistant - a necessity for transformer enclosures). Capacity 2.0A at 16 Volt open circuit - and 12 Volt under load = 24VA (DC). Primary supply 110-120V. Polarized socket for MICROMOT plug. Red LED indicates readiness for use. Modern design with holes for storing bits. Foldable tool rest provides a secure place for keeping the tool ready for use.
You may also want to consider a Keyless Chuck to use with either Handpiece for fast bit changes. Accepts accessories with shanks from 1/64" - 1/8" (0,5 - 3,2 mm).
You will need a housing collar to use the Keyless Chuck with the #50 and #50E