The Micromot 50E and 50 models are lightweight high precision tools. The diameter of only 1 3/8″ makes the tool very easy to handle. They are ergonomically formed to allow comfortable handling and optimal control. Their quietness and effortless, vibration free drive all contribute to the ergonomic design. An efficient cooling system facilitates extended use under various load conditions. Both tools are usable on any workable material e.g. steel, precious metals, wood, glass, etc. They are ideal for model builders and woodcarvers.
The electronic speed control enables the selection of speeds from 5,000 to 20,000 rpm. Phase angle control and feedback effect circuitry yield high torques, even at low speeds.
Other features are the same as the #50 without speed control.
Four MICROMOT collets for shanks covering 1/32″, 3/32″, 7/64″ and 1/8″ (1,0 – 2,4, 3,0 and 3,2 mm) are supplied.Technical data:
Proxxon Micromot Drill 50E Speed Control Technical Data:
Direct voltage 12 – 18V. Power absorption up to 40W input. 5,000 – 20,000/min. Length: 8 21/32″ (220mm). Weight: 0.51 lb (230g).
This Proxxon AC Adapter NG5 Variable Speed control comes in a compact Noryl casing. The Noryl material is heat resistant and recommended for transformers. The thyristor electronic control with feedback allows for optimum tool speed and high torque at low speeds.
The vise is made of die-cast zinc and has three machined sides. The grooved base fits perfectly the adjustable fence of of the Drill Press.
The jaws are 2" (50 mm) wide and 25/64" (10 mm) high and provide horizontal and vertical V-slots for holding round work pieces.
The maximum clamping width is 1 11/32" (34 mm).